roaming | precisionIH - 5/23/2016 10:38
No sorry I forgot to say it did not engage during the roll calibration. I was thinking about changing out the autosense sensor out or clearing the memory on the NAV. Just wanted to make sure I wasn't forgetting anything.
Ok, so at least it's consistent.
Both of those are probably good steps. Also make sure that the Autosense is installed correctly (connector to the front). I'd clear the NVRAM in the Nav before replacing Autosense.
Edited by torn 5/23/2016 11:44
|
NAVll/Pro700 says it's going backwards
