|
Central IL | I bought a new to me BBI spreader that had a 4400 raven monitor. I put a node on the spreader and am now planning to run it through my pro 700 vt and using a task controller. Problem, the rpm gauge on the vt screen is pegged. Put new bolts for sensor to read on spinner, new weather pack connection at sensor (it was corroded pretty bad), and now new sensor and still no change. What to check next? My bin level sensor is in the same harness and it seems to be working fine. Thanks!
Edit to ask: Also when using task controller to variable rate and map products how do I enter the correct product? In my work condition screen layer 1 is "gran-spi/actual rate" but the product is TC other 1 and is greyed out. This is when a dap rx is loaded.
Edited by Case IH Farmer 12 7/31/2015 21:28
(image.jpg)
Attachments ---------------- image.jpg (124KB - 130 downloads)
| |
|