|
| I install two small fuse blocks, each with a 10 ga wire direct to the battery. One is used for "clean" power, GPS, PDA, controllers, etc. The "dirty" power fuse block gets valve drivers, anything with relays, etc. I use "clean/dirty" isolated ground bars also. This saves time when adding equipment. I have never fused a ground wire, although I can envision a way to melt wires. The spreader with the 332 goes back to work today with about 13 volts (1 V more than before) as measured by the Trimble internal voltmeter. I am also taking a spare antenna cable along. I'll let you know what happenns. | |
|
Does the 332 Trimble need more than 12 Volts?
