| FarmerFrank - 11/28/2012 09:33
This was my case. Vermeer baler on a 4630JD power shift, so running 1000 rpm shaft. The constant pull/push on the shaft had worn grooves in the little balls and rather than just pulling and forcing I had to slide it back ON and use some finesse. Turn it and tap,turn and tap. Finally, got it unhooked.
Then replace the balls when you get it apart.
We've had the balls sort of mushroom the splines where they seat in the groove. Makes a real pain to get off as hub splines in front of the ball area don't want to slide past the messed up splines. |