|
KY | Lower houred 14 series or just about any 16 series IH without chopper will bale just fine. Been doing it around here since the early 80's. If you're used to wrenching on that 715, not much has changed for you on a 14 / 16 aside from the obvious. Clean grain, tailings, pretty much same spots, same wrenching. I have no experience with gleaners and older NH's, but I promise you if you're going well used like I do, an IH/CIH is going to be easier and like as not cheaper, to wrench on. | |
|
finding the right combine
