Near Intersection of I-35 & I-90 Southern Mn. | On a virgin setup, entering the C11 number changes the C2-C10 numbers proportionately so that you do not need to enter them.
On a used system, it is often necessary to set the C2-C11 numbers each manually as you have found. This is not difficult but takes a bit of time.
As has been stated, the system will use these C2-C11 numbers to compute the yield in the 10 flow categories for your combine. When you perform a calibration, these numbers are changed somewhat to better reflect your situation.
The C1 number is the vibration calibration number. This number is changed by the system when you perform the Vibration calibration. This number is not changed when weights are entered for the Calibration loads.
Edited by tedbear 9/27/2011 06:40
|
agleader C1 to 11 numbers
