|
Southern NJ | Looking for some help troubleshooting an issue I'm having with a 2008 Reinke Center pivot. Something is causing a voltage drop on the system (from 480V down to 430V) and causing it to turn off. Today I saw the voltage meter drop to almost 400V. Its not the end gun booster motor because it has done it with the booster off. Sometimes the system will run all day without turning off. Today it shut down a couple times in two hours. I would like to think that one of the electric wheel drive motors maybe has a bad/dead spot in it, and when the system stops at the bad stop and then goes to start its causing the voltage drop and then shutting the system down.
This is a basic 5 tower percent timer system.
I tried to stand there and watch to if a certain wheel motor caused the issue but didn't have much luck.
Any advice would be greatly appreciated.
| |
|
Reinke Pivot Troubleshooting
