AgTalk Home
AgTalk Home
Search Forums | Classifieds (89) | Skins | Language
You are logged in as a guest. ( logon | register )

7110 magnum a/c
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
Posted 3/13/2019 19:59 (#7378694)
Subject: 7110 magnum a/c

Replaced the belt to the a/c compressor last year becuase it was squealing. Old belt wasn't too bad but new belt shut her up. Now its back at it. Nothing getting on it, its tight but getting hot and squealing. Anyone have this issue before? Could one of mu pulleys be getting worn? Have not checked to see which one is hotter yet. A/c still works good but maybe compressor is getting harder to turn? Just looking for you guys opinions.

Also my 3 point arms were slowly going down and now i am pretty sure i have a leak somewhere internally. Thinking rockshaft seals. Have not capped off assist cylinder yet but noticed a small oil spot coming from rockshaft. So what else should i check before tearing into it. I assume there is some sort of load check valve somewhere but i have no idea where it is.
And if it is rockshaft seal how do you go ahout replacing it? Remove fuel tank and remove the whole top housing there?
Top of the page Bottom of the page

Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)