|
NW Oklahoma | Installed a wash bay in the back corner of the shop with hot and cold water lines ran inside the red and blue corrugated covering before I poured the pad, approximately 150 ft of line.
Installed the faucets on the PEX tubing to clear the lines with the intent on mounting them on a plate on the wall. The hot and cold faucets were the same height when I first installed them and upon the first use the hot grew that much, which I thought was no big deal assumed it was a one-time thing however the line still moves 2 1/2 to 3 inchs every time it's used. Now I'm scared to try to mount it solid. Anyone have any ideas how to make a clean install. Hate to just leave the faucets dangling on the pipe. I had no idea there was that much expansion and contraction in the PEX tubing.
(pex1 (full).jpg)
(pex2 (full).jpg)
(pex3 (full).jpg)
Attachments ---------------- pex1 (full).jpg (174KB - 67 downloads) pex2 (full).jpg (146KB - 68 downloads) pex3 (full).jpg (143KB - 63 downloads)
| |
|