Between Omaha and Des Moines, 7 miles South of I80 | Spraying yesterday, about 3-4 times, when I would flip the Master Switch back "ON" the screen wouldn't change, thus No Spray. {I flipped it up and down a couple of times, then it would work, normally} I use the Master, at each turn, because the "pink" boom coverage(Booms OFF), on the monitor helps me see where to "turn in" on the next rows. Note: I did build a foot controlled implement switch(dimmer switch), but it doesn't change the Integra screen to "pink" when I operate it, so I'm back to using the Master Switch on the SC110 console. As one person mentioned earlier, that Ag Leader could sure improve their "screen colors" because in the sunlight, it is too hard to see the difference "boom width verses coverage"= this is why I use the master switch, so often. Anyone had the Master Switches, replaced? Common toggle or something special? (like gold plated contacts, internally, for low voltage electronics) Thanks
(SC110_ in paint program (full).jpg)
Attachments ---------------- SC110_ in paint program (full).jpg (81KB - 155 downloads)
|