|
Nebraska | I am having problems with my rate and section control for raven replacement not being found or connecting with my FM1000 display. I had, prior to today, installed the 6.01 firmware I got from the dealer. After making sure that my raven cable had good voltage, I then decided to reinstall the firmware. After doing this the IQ was recognized by the display. While it was connected I upgraded the module firmware. The problem is: every time I turn the display off and turn it back on the IQ isn't connected or recognized. I reintsalled firmware again and it connected until I powered the display down and restart it.
Has anyone had a similar problem or an idea what to do to keep the IQ connected?
Thanks | |
|