|
| I replaced the entire set of cables for my 4020, took the floor plate off and everything. To begin with there were four sets of cables, now now only three makes sense. Positive to starter, negative to positive on the other battery, then negative to ground. Where was the fourth supposed to go? Was there a ground or some special meeting place under the floor where the extra cable met in between the two batteries or should I just use three, since it appears to work, and put the floor back in place.
This tractor sat for TEN years before I got it going so it's kind of screwy but it runs good, I'm just trying to get it set up so it doesn't burn to the ground before I have some one come to look into restoring it for me. Several bolts underneath the floor are broke off as you might imagine, so I have to figure out how to get them out.
This is a lot to ask, but does anyone have a pic of their 12 volt 4020 with the floor off?
Thanks in advance!
Edited by kwc27 10/16/2011 09:05
| |
|