|
Strathcona, mn | Having an electrical issue. The unload light always stays on the top panel. We have replaced proximity sensors with known good ones, checked voltages between a combine with working system, switched control boards, etc…. And we can not get the light to go off. With light on the auger clutch will engage in any position resulting in damage, thus how we found problem. Any ideas? Anyone know how proximity sensors work? They will not show open or closed as in a normal switch, we have 3.5v roughly to signal wire. They must show a voltage drop through bus to computer board. Boy I wish they were just open and closed mechanical switched like on the old ones, lol. | |
|