|
SW MN | I have a Raven 450 on my planter for starter fertilizer. It says it is putting on 0 rate even though it is applying.
Tried swapping flow meters and that didn't fix it. Looked at control valve and that seems to be functioning properly. I tested voltage on the flow meter cable and get 5VDC on pin 2 and only 1-2V on the signal wire. My understanding from the raven troubleshooting guide is that there should be 5V on the signal wire as well.
I have traced the wire back to the console cable and still get 2 volts on the signal wire.
Am I missing anything or do I just have a bad console cable? | |
|
Raven 450 0 rate when applying
