|
Ossian, IN | I have a couple questions about some MacDon drapers. We don't own one, never used one and haven't seen one run up close. We are fairly flat ground, except for some gulley's here and there and our combine is a level land. From what I've read, apparently a D60 & 973 are rigid, but will pivot some with the ground based on the coil springs near the feederhouse. Is this correct? And some say that some do or don't have automatic header height?
This would be going on a JD 9500, maybe eventually a 9510-9550. Some of the one's I've seen listed on TractorHouse will say set up for JD 50 series. Is that just meaning it's got the telescoping shafts? Or if equipped with header height, it is set up differently? At some point in the past life of our 9500, it had Headsight on it as there was a little control box with a dial & little LED lights in the cab, although we aren't sure about the rest of the wiring. | |
|
MacDon D60 & 973
