|
| Tractor will run strong then quit moving and flash "sensor failure" light. Lots of codes E32-41, E64, r13. Won't go into gear unless you shut the engine down and let it sit for a couple hours.
I have been reading a lot of posts and am trying to locate Rev, mc1, & mc2 solenoids to swap them out. Which ones are they on the bank?
I have redone the cab and battery grounds. I have pulled & reattached the 2 plugs infront of the clutch pedal. I haven't found any bad harness wires. What else should I try?
Been acting up worse and worse over the last week. Not fun when it quits moving on the 2 lane hilly blacktop.
Thanks! | |
|
Solenoid Failure Light-Funk 18spd Tranny- Agco 9690
