|
| I have a new Go 10 console and am trying to run a Deere 1990 air drill with ag leader clutches. Have ran this with an integra and Incommand 1200 in the past. Just getting started and in Virtual Terminal I get an alarm and the message “ground speed not detected”. The drill is planting but the row monitoring is not working at all. No population either, which makes sense if it isn’t seeing speed. Under settings on the Deere screen in VT it shows ground speed and wheel speed. Ground speed does show up there correctly and matches the speed shown in the ag leader side, but wheel speed stays at 0. What do I have wrong? | |
|
Ag Leader Virtual Terminal speed not detected
