|
| I bought a 9510R scraper special last fall and was hoping to auto track with the tractor. After plugging in the receiver and display I see there is a blank space where auto track on/off button should be on bottom right of display... looked over and no resume switch in the console. I do get communication between display and receiver and had RTK signal. After lifting the console to install resume switch it is not readily apparent where it would plug in. I am wondering if this tractor is equipped with all the necessary equipment from factory. I thought most if not all Deere tractors after about the 8030 series were all equipped with valves and harnessing. Can anyone help me out on this? Am I just needing another harness? What am I missing?
Edited by neptune 7/22/2026 17:59
| |
|
auto trac switch install on 9510R
