|
NE Indiana | Vector hd580 with ceres software if that matters. While spraying if I get my boundary to close to a tree line it will say cannot avoid obstacle and need to manually control it to get to the next pass. As soon as I hit resume it goes right back to the place that it got stuck to try and resume spraying. I’ve manually toggled the spray while manually maneuvering it and it doesn’t matter it still wants to go back to where I took over. I feel like this can’t be right and I’m doing something wrong. Anyone have any advice. Ideally the software should let me adjust the boundary but I haven’t found a way to do that without starting a new task in the field and then it just wants to start over for the whole field. | |
|
Vector hd580 obstacle avoidance
