|
Bunker Hill, IL | I bought a BPF11878 harness to install to my V2 server on my 7210R with a 4600 screen. I’m using an Ag Leader InCommand 1200 and GPS 7500 for autosteer through isobus. I’m wanting to send gps signal through this serial cable to the Deere screen for mapping and section control.
I have the com1 serial port enabled, and on the InCommand, have the Port B set to 19200 baud rate, 5 Hz, selected GGA(position), VTG, GSA, and RMC.
I’m seeing a speed and position on the Deere, but it seems intermittent even though the speed is a good reading. Only seems to move my position on the Deere screen every 1 second +/-
I’ve tried different baud rates and position rates and none other work at all.
Do I need different settings, or do I need to try something different like a roll compensated gps output from the Z2 steer controller?
 (IMG_4176 (full).jpeg)
 (IMG_4177 (full).jpeg)
Attachments
----------------
 IMG_4176 (full).jpeg (116KB - 3 downloads)
IMG_4177 (full).jpeg (149KB - 2 downloads)
IMG_4178.mov (10857KB - 2 downloads)
| |
|
Deere serial GPS from Ag Leader
