|
Le Sueur VIA St.Thomas | Ok, so let's say I have a thin piece welded to a thicker piece, kinda like the pic shows. If I wanted to 'harvest' the thicker piece with minimal grinding or gouging of the thicker piece, I'd torch it like shown, sacrificing the weld and smaller piece.
Questions: is there a better way? I suppose no one makes a special tip that could be drug along the base without cutting at an angle, do they? Other ideas? Grinding is noisy and messy, and gouged material looks bad :^( My resources currently limit me to acetylene and grinding for the most part.
TIA -jim
 (Scan_Pic0023.jpg)
Attachments
----------------
 Scan_Pic0023.jpg (8KB - 254 downloads)
| |
|
Cutting out welds- flush
