|
NW Iowa. / SW Arizona | I have a Artsway PM 30 grinder that on the auger feeder over the years I have put a bunch of dents in the tube. This was accomplished by not lifting the auger up high enough & putting it in the holding saddle. Not sure if you can see it good enough but it's dented in a good 1" to 1 1/2" in places probably 6"-8" long. I know body shops have tools to help pull these out but I'm no body shop owner. Any ideas are appreciated, thanks.
 (008.jpg)
 (011.jpg)
 (012.jpg)
Attachments
----------------
 008.jpg (28KB - 160 downloads)
011.jpg (96KB - 160 downloads)
012.jpg (93KB - 173 downloads)
| |
|
Need ideas on how to take out dents in auger tube
