SW NE | We are looking at building custom silage trailers that sit on tri-axle manure tank chassis. A local welding shop has built a few in the past and has used a variety of hydraulic cylinders. So here goes the list of questions that hopefully a few of you can give advice about:
1. We are thinking of using semi dump trailer hoists. Could a hydraulic motor (operated by one of the tractor hydraulic remotes) turn a hydraulic pump to pump the oil into the cylinder. We are thinking we would then need some type of hydraulic valve operated by another remote to allow the oil into the cylinder and then back to the tank after dumping the load. Is this possible?
2. If #1 wouldn't work, how about a PTO operated pump that is attached directly to the PTO, no shafts? How much would one of these pumps cost?
3. Are there any "scissor" type hoists available with 40 ton capacity that could simply be operated from the hydraulic remote? |