|
| Purchased a new old stock 3020 head from an equipment jockey and are having some problems getting it set up. The main problem we are having is getting it to cut and not push trash and then dirt in front of the cutter bar. We have tried three different header pitches and finally have it set at approx. 15 degrees right now, timed the cutter bar because it was off 1/4 to 1/2 an inch, tried different things with the reel but none of it seems to have completely fixed the problem. It also has hydraulic adjust on the torsion springs which we have tried in several positions and tried to make sure they were adjusted evenly across the head. Doesn't seem to have one place it likes to push the whole head can do it at different times. Driving on an angle helps to a point. Timing the head seemed to improve the cut so that during the day when the sun is out and you keep it under 3.5mph your good. Have tried messing with the sensitivities and height of the head to no avail. The beans have some green in them but they are testing 11-13% moisture. However when the sun starts to go down you might as well go home it just wants to push trash. Head is on an 8120 and was wondering what speed we should run the feeder house? Neighbor has one and seems to get along with it and he even runs some double crop beans with his which can be challenging. Keep thinking it has to be something simple. Any help is appreciated as long as it doesn't involve telling me I need a $80,000 draper. | |
|