|
Eastern NC | I am reposting this from Machinery talk to see if I get any replies here.
My 2630 in a 9670 sts has a MTG installed and normally sends yield data with no issue when changing fields. I had a field that took over a week to complete (rained out) and it will not send the info to JDlink/Op center. I have tried re-opening the job and closing again... still no yield map in op-center. I tried putting the data on a thumb drive and it failed to transfer 1 file (probably the one I need).
possibly unrelated, I lost my "coverage map" in the middle of the job. It was after the rain and I think due to changing the swath width of the header. I needed to allow more over lap because with the mud I was not driving straight. More like sliding crab style with some "S" action. I know that changing set-up info can start a new coverage map, but the yield data is still in the 2630. I just cant seem to get it to Op center.
Let me know if there is fix, or if I can answer a question that I didn't know mattered.
Thanks
| |
|
JD 2630 not sending yield map to Op center
