Thanks for the help.  I got into toolbox, but didn’t get to calibration.  I was running out of time yesterday.  I didn’t think of it until I went to install the two outside tires on the main frame, but I should have used my Emerson air jack to align up the bolt holes on the inside two tires.  That would have prevented this problem.  I did check the connector and the linkage when I was working with it yesterday.  Everything was connected.  When I get into calibration, I will watch the graph and see what is going on.  

I do the same thing as you do, when filling up bulk tanks with the planter folded.  It is nice to lower the center section closer to the ground.  It makes it easier to climb the ladder and the spout on the seed tender is more useable when it isn’t collapsed.  Snow on the way, so it may be tomorrow before I pull it back out of the shed.  Happy Easter !