|
| Sounds like your planter IS already equipped with a priority flow divider valve, and that should work just fine if 1) hydraulic cooling system can handle the heat load which it probably will, and 2) you can deal with the fan low disruption when you raise & lower the planter. One other thing: normally the return flow is returned to the external fitting just above the hydraulic filter housing (steel tube leads from the remote valve bank to that fitting.) The reason for this was to keep the hydraulic filter housing kind of "supercharged" and also to prevent the return flow of hydraulic oil from creating excessive aeration in the rear transmission housing. I would recommend returning the flow to that fitting. Good luck! | |
|
1086 International Hydraulics
