|
| I made this for a JD 643. I made it when I had a 7700 combine with 28L26 tires that would not lift the corn head very high so I needed to build it like this to get the head cart low enough to work good. One side has small tires and rims from shoup and the other side I put small car tires on it. I had to notch the main C-channel support to fit the supports that hang down off the corn head. Both the 6x6 and the C-channel are held on by pins that I can move to different holes to accomodate different heads if the need ever arises. The last pic is why I needed to notch the C-channel.
I had to lengthen the wagon tounge also.
Edited by sparrell 11/20/2009 13:15
(DSCN1880 (Small).JPG)
(DSCN1881 (Small).JPG)
(DSCN1882 (Small).JPG)
(DSCN1883 (Small).JPG)
(DSCN1884 (Small).JPG)
(DSCN1886 (Small).JPG)
(DSCN1887 (Small).JPG)
(DSCN1888 (Small).JPG)
(DSCN1889 (Small).JPG)
(DSCN1890 (Small).JPG)
Attachments ---------------- DSCN1880 (Small).JPG (51KB - 2092 downloads) DSCN1881 (Small).JPG (49KB - 2194 downloads) DSCN1882 (Small).JPG (46KB - 2237 downloads) DSCN1883 (Small).JPG (49KB - 2158 downloads) DSCN1884 (Small).JPG (37KB - 2259 downloads) DSCN1886 (Small).JPG (48KB - 2228 downloads) DSCN1887 (Small).JPG (47KB - 2185 downloads) DSCN1888 (Small).JPG (51KB - 2213 downloads) DSCN1889 (Small).JPG (46KB - 2384 downloads) DSCN1890 (Small).JPG (37KB - 2462 downloads)
| |
|