|
| I have a JD 9560RT that tries to stall every time I start it. It happens directly after it sounds like it’s going to start and then slightly stalls out but usually stays running. After that it runs perfectly fine. We have replaced everything on the fuel side including pumps and filters. I noticed today that when it tried to stall the digital readout corner post flashes which leads me to believe it’s an electrical issue and not a fuel issue. I’m also getting an over voltage alarm on my 4640 monitor for my mueller controller that runs my strip till machine every time I shut it down which is plugged into my ISO plug in the back. It still stalls even if I unplug it. Is there a chance it could be a faulty ECU or a short in the wiring somewhere? JD hasn’t been able to figure it out. | |
|
John Deere 9560RT stall issues
