|
west tennessee | crop flow detected but not logged when thresher engaged.Adjusted c1 value a little at a time until no visible flow reading.Only sometimes while dumping it may show 30bph for a few seconds.Hopper only holds 300 bu with extension.Before calibrating, the monitor claimed over 500 bushels per hopper.After numerous(8 or more) cal tasks I have gotten it down to around 340.Beans are in the mid 50 bpa range and the monitor usually isnt much too high,but sometimes its showing mid 90 and 100 bu yield.Is there a sure way to test the sensor for failure or should I just bite the bullet and buy a new one? Thanks for any advice! | |
|
2388 afs flow sensor cal not working
