|
NS Canada | Alright, so I found a schematic. And something is definitely screwy. This shows the black line should be going into the smaller end of the valve, and the barbed fitting on the other side. Odd thing about that though is then it is pointing in the wrong direction, towards the back of the machine for the bead blast assembly, which is on the front.. but it does show a bend in the tubing. So whoever had this before me was in there changing things around it seems, which explains why the bead blast never worked.
Can anyone decipher a spring labeled as '12,3x1x24 C spring' So I can figure out if its the correct spring installed?
Edited by Supa Dexta 5/21/2021 10:56
(schem. (full).png)
Attachments ---------------- schem. (full).png (122KB - 29 downloads)
| |
|