|
Wisconsin | Lots of great advice. Low rib panel with consistent ribs. One piece if you can. As said before the sheets tend to grow wider where the curve is most and where the sheets seam. Used to do a fair amount of this work, it takes longer than you think. Having a lift(s) that can reach the entire height is very helpful. The sheets etc are not too bad but putting on the last of the trim or last sheet from the roof can produce a bit of a pucker factor. Be safe. If your in Wisconsin Harte lumber would be my go to for buying steel. Not only can they get you what you need but they also have answers. | |
|