|
SW MN | Looks like this thread really took off but no one answered your questions here. I only have real experience with the Deere stuff, so I don't know for sure with your Integra or your Kinze system. If the population monitor on your planter is ISOBUS compatible, then yes I believe it would show up on the 2630. I used a Deere planter and Seedstar 2 in my example above because I know that one is ISOBUS. I don't know if your row clutches will work, though, unless that whole system is on the planter and not in the Integra. Again I don't know about Ag Leader. But in the case of Deere displays with Deere planters, section control is run with the display and requires an activation - it can control the planter (or a rate controller on the planter) to operate the row clutches, but the brains are inside the display instead of in a controller on the planter. As opposed to the Seedstar population monitor, where the brains are on the planter and any ISOBUS virtual terminal can allow you to interact with it. | |
|
ISOBUS - CANBUS (explanation for dummy’s)
