northeastern Ohio | c_mayer - 11/15/2020 09:03
Steering column I haven't seen move. Probably the gas shock in it needs replaced, valve isn't holding.
Bolt in roof...there's a cover at the front of the roof, but the rest of the roof just sits on there with a few screws holding it down. Shouldn't be hard.
Speed sensors...could be sensors, could be software bugs.
If the machine has warranty, all concerns should be covered. If it doesn't, grab speed sensor and a gas shock, not expensive or hard fixes by any means.
As far as AG Leader...if it is Ag Leader ready, with a moisture sensor on the back side of the clean grain elevator, then you can throw an Integra in it, or run the AG Leader yield data through the ISOBus on the Tyton terminal in the cab. If it is AGCO Yield only, then it still runs through the Tyton in the cab. Yield monitoring of some sort is standard equipment, and can not be opted out of, so it has it. May just take some instruction on operation.
Chris
This a 2018 that was put in service in Sept 2019. Extended Warranty is good to Dec 2022. Previous owner said he had the software updated fall 2019 to fix the joystick response. He didn't have any other issues. Maybe there is a newer update.
Not Ag Leader ready. I've been running Ag Leader stuff for 10 years, so it is hard to learn a different system. I'll do some reading on a rainy day to see if I can figure out this Agco yield monitor. |
Gleaner S96: my first day running
