|
Jeffersonville, OH | Steering column I haven't seen move. Probably the gas shock in it needs replaced, valve isn't holding.
Bolt in roof...there's a cover at the front of the roof, but the rest of the roof just sits on there with a few screws holding it down. Shouldn't be hard.
Speed sensors...could be sensors, could be software bugs.
If the machine has warranty, all concerns should be covered. If it doesn't, grab speed sensor and a gas shock, not expensive or hard fixes by any means.
As far as AG Leader...if it is Ag Leader ready, with a moisture sensor on the back side of the clean grain elevator, then you can throw an Integra in it, or run the AG Leader yield data through the ISOBus on the Tyton terminal in the cab. If it is AGCO Yield only, then it still runs through the Tyton in the cab. Yield monitoring of some sort is standard equipment, and can not be opted out of, so it has it. May just take some instruction on operation.
Chris | |
|
Gleaner S96: my first day running
