|
NE Neb | 1st pic is the wedge that's used on a 8200 bean head. This plate came on a head i had already bought. I welded a 1/2 plate across the bottom and bolted the wedge plate to it and my bottom was done. 2nd pics I just welded an angle on to make the V that the throat hooks up into. Another angle on the front of it and a flat welded between. I cut the plate on top of head so throat could come closer. Had to weld flat plates on the outside for bearing blocks and order 2 drive shafts. It's crude but I did it in a day.
Edited by Next stop Valhalla 9/19/2020 17:10
 (IMG_20200919_163038231 (full).jpg)
 (IMG_20200919_163046651 (full).jpg)
 (IMG_20200919_163729995 (full).jpg)
 (IMG_20200919_163201635 (full).jpg)
 (IMG_20200919_163151412_HDR (full).jpg)
 (IMG_20200919_163221558 (full).jpg)
Attachments
----------------
 IMG_20200919_163038231 (full).jpg (194KB - 117 downloads)
IMG_20200919_163046651 (full).jpg (283KB - 203 downloads)
IMG_20200919_163729995 (full).jpg (214KB - 103 downloads)
IMG_20200919_163201635 (full).jpg (138KB - 89 downloads)
IMG_20200919_163151412_HDR (full).jpg (135KB - 136 downloads)
IMG_20200919_163221558 (full).jpg (154KB - 210 downloads)
| |
|
MF 1183 vs. 883 Corn heads
