|
scmn | Your best bet will likely be an A&I dealer.
Here is a link to the KB61/20 clutches that are offered. You will need to measure yoke to figure out series (2200, 2300, 2400, etc) and count the splines to see if it is 1-3/4-20 or 1-3/8-21 spline and then locate it on the site and give that number to your A&I dealer. You will likely have to match up shear bolt size (8mm or 10mm) and shear bolt location too.
https://www.allpartsstore.com/ItemList.htm?CategorySeq=B&SelcBrand=W...
FWIW aftermarket PTO parts are expensive when buying just a yoke, sometimes the OEM complete shaft might be cheaper by the time you put the cross in also and sometimes it is the only viable option. | |
|
PTO shear pin
