|
Northern IN | I wish my video would load I attached in earlier post. The retainer on mine didn’t move and the yoke did a fuzz new yoke was much tighter on shaft splines vs old yoke when I flipped the retainer there was a wear ring on out side edge 1/4” in where yoke wore away at it so new yoke, retainer, o-ring is what I replaced I will say when we installed a new dampener it did sound a little better but didn’t clear it up I figure that the new rubber absorbed more chatter from the pto shaft vs the old one with hard rubber | |
|
Case ih 335 Steiger idle chatter
