|
Kingston,Mi | I mounted a Prince unit from Shoup in the cab of my JD2940 and fabricated a mount for a new valve and attached it to the frame of a JD 640 loader. The joystick mount is fabricated from 1 inch box tube, 1 inch strap and a few odds and ends. It attaches at the floor and with the strap to the front cab roll bar post. Push/pull cables go thru a hole drilled in the floor and to attachments on the valve. I think the push/pull cables are 4 or 5 feet in length and have to make a sweeping curve to line up with the valve placement.
Edited by BOGTROTTER 5/3/2020 14:31
 (IMG_0968 (full).JPG)
 (IMG_0969 (full).JPG)
 (IMG_0966 (full).JPG)
 (IMG_0967 (full).JPG)
 (IMG_0972 (full).JPG)
Attachments
----------------
 IMG_0968 (full).JPG (107KB - 33 downloads)
IMG_0969 (full).JPG (196KB - 43 downloads)
IMG_0966 (full).JPG (67KB - 28 downloads)
IMG_0967 (full).JPG (99KB - 38 downloads)
IMG_0972 (full).JPG (110KB - 19 downloads)
| |
|
John Deere Hydraulic Joystick
