You are talking about a Kinze brush meter correct ?

Not a 56 cell JD radial bean meter

Not a actual plate like the old style plate planters ? Not sure but I think those could have been an option on a 7000 but were sort of uncommon.

Basically you want to set it for a 32K corn rate.

12 fingers in a corn meter so it's a 5:1 ratio for the 60 cell plate.

32,000 x 5 = 160,000

Here are the stickers for the 7000 planter

https://www.joharrissales.com/assets/Uploads/PDFs/PlantingCharts/Transmission-Diagram.pdf

You have the older sticker at the bottom which uses double length chain. The top sticker is for those that have newer style sprockets. Don't worry the ratio is still the same on both stickers.

Here is the finger pickup chart

https://www.joharrissales.com/assets/Uploads/PDFs/PlantingCharts/FPU-Chart.pdf

See pic 1 below for the 32K rate and 22-18 sprocket combo.

See pic 2 below for the correct 22-18 sprockets for the regular tooth transmission.

See pic 3 for the 11-9 tooth sprockets for double length chain you have.

Pic 3 is what you have.

11 bottom shaft driver

9 top shaft driven

Pic 4 are your sprockets

Previous discussion of all of this.

https://talk.newagtalk.com/forums/thread-view.asp?tid=618288

Here is Gerald J's post about the different chains and sprockets

https://talk.newagtalk.com/forums/thread-view.asp?tid=618288&posts=1#M5171387

(1 (full).JPG)

(2 (full).JPG)

(3 (full).JPG)

(4 (full).jpg)

1 (full).JPG (138KB - 333 downloads)

2 (full).JPG (58KB - 270 downloads)

3 (full).JPG (70KB - 284 downloads)

4 (full).jpg (102KB - 285 downloads)