|
| I have a HCI - Prince C-503 valve that was laying on the shelf, not certain of its previous purpose. I want to use it to control a hydraulic motor on a spinner for a dry fertilizer spreader. Is it appropriate for that application. If so, how do I plumb it? I would be using a JD 8000 tractor if that matters.
Edited to add that the nipple fitting in the upper right is brazed shut
Edited by Beanstubble 1/11/2020 19:54
 (valve (full).jpg)
Attachments
----------------
 valve (full).jpg (229KB - 36 downloads)
| |
|
Hydraulic flow control valve ?
