South Georgia | sunman - 1/9/2020 13:03
Take the auger out for safety. Then take the moisture sensor out. Reach in with your fingers and touch the round, white proximity sensor. It should show a little light on it when you touch it...at that point you should hear a click and the motor will run. No light - change prox sensor. If you see a light with no click...possibly the relay. Replace it - it's cheap. Still don't work? replace the control circuit. You have already tested the motor. Assuming all fuses are ok first...
I had a relay go bad on one this fall....it happens.
I haven't tried that this winter, but during harvest putting my hand over the proximity sensor would not make it run. I don't remember if there was a light there or not, but I do know that pressing the manual clean out button didn't work either.
Thanks,
Adrian |