|
North Central Ohio | Take the auger out for safety. Then take the moisture sensor out. Reach in with your fingers and touch the round, white proximity sensor. It should show a little light on it when you touch it...at that point you should hear a click and the motor will run. No light - change prox sensor. If you see a light with no click...possibly the relay. Replace it - it's cheap. Still don't work? replace the control circuit. You have already tested the motor. Assuming all fuses are ok first...
I had a relay go bad on one this fall....it happens.
Edited by sunman 1/9/2020 13:04
| |
|