Planting was done with a SF3000 and 2020 monitor w/ digifarm RTK. Combine has a trimble 252 and AgLeader Integra w/ cors RTK. 6 row planter and corn head. I was hoping the passes would line up better for our hybrid side x sides but it looks like the harvest map is about 1 row or 30 inches east of the planting map.
The receivers were both centered with no offset on both machines on level ground. I don't think it's an offset issue as subsequent passes going different directions line up and I think that creating an offset would cause overlap on one side?
Any ideas?
Edited by tlarson4430 11/15/2019 05:26
 (offset (full).jpg)
Attachments
----------------
 offset (full).jpg (97KB - 92 downloads)
| 
Planting map not lining up with harvest map
