|
SE VA/NE NC | The newer I-1200 and I-2200s have a 5 bolt tapered with the coil. They are massive. I have 4 of them just for dimensioning. Id like to stick with those for thhe reasons you mentioned. But I could take anything and weld in a new spindle and convert the bearings.
The only Salford I have found cheap are the RTS models, which predate the I series and are much cheaper, but still $30,000+, and being the wider 7" spacing, I would pretty much need two of them to get enough shanks.
I was just hoping someone was making these for Salford and not salford manufacturing them themselves.
Edited by HoRFarms 8/4/2019 12:56
| |
|