|
Eastern Arkansas | I used a cab kit for a Freightliner cabover. Left the stock front cab mounts. The hood was already raised 2 inches to clear the intercooler on the Detroit. Ended up making spacers to raise the cab an inch in the front then mounted the air ride cab kit where the cab was level. It makes it line up with the hood a little better and gives some clearance underneath. Used a 12v Amazon air compressor with a pressure switch and 2 gal tank. Moved around an inch up and inch down in the rear. I only have $500 or so in the whole setup.
I’m going to build a custom kit for my industrial.
Edited by reedfarmer 7/4/2019 16:32
 (27FDF0AD-EF7F-4771-A733-3FAFFA024273 (full).jpeg)
 (2FE3CB5F-30DC-4520-B09A-97E744E4D559 (full).jpeg)
 (C1BEDE67-303A-4E8E-B124-C206220BD859 (full).jpeg)
Attachments
----------------
 27FDF0AD-EF7F-4771-A733-3FAFFA024273 (full).jpeg (217KB - 30 downloads)
2FE3CB5F-30DC-4520-B09A-97E744E4D559 (full).jpeg (255KB - 22 downloads)
C1BEDE67-303A-4E8E-B124-C206220BD859 (full).jpeg (161KB - 24 downloads)
| |
|
Steiger Industrial CA325
