|
NW Iowa | If you hit the left button on your keypad by the dash once, it will show any active codes, if none it will go to the brightness contrast screen. Is there any?
When I start a machine, I put my foot on the brakes and pull the park switch after a couple of sec. It won't move until that red hyd brake pressure light to the left side goes out. Usually pushing on the brake will facilitate that.
Also make sure the park is on first or you will have to toggle it on then off.
If you have the engine minder on it won't move until you rev up the engine. I always leave that stupid thing off
Make sure it is in turtle or hare and it is not flashing between the two.
If your starting speed is set at 0 you will have to hit your propel lever to get it to move after putting the forward/reverse lever in gear
If all else fails hit the battery disconnect under the panel by your right foot and restart.
Edited by Massey1155 6/7/2019 21:19
| |
|
Massey Ferguson 8650
