|
| I had a few minutes to check a few things:
Transmission sensor (x19) - sensor tested at 478 ohms. It's been sitting in the shed for 24 hours. The display on startup read 77F. That reading sound OK? It's a little warmer than 77, but not a lot more.
I tested the plug. Found ground and it was good. Tested across the pins with the key on and got 6 V. That sound OK?
On startup, E4332 was gone. E4356 still there.
I took the battery cover off. Checked tightness of the 4 battery clamps. All are tight now. One + was a little loose and I had tightened one - Monday evening. Took the module in there loose to check clamps. Cleaned the + mount up and put back. Started again and E4356 is still there.
What group are those batteries??? Looks like they will be fun to get out. I couldn't tell for certain if they are original and I didn't have time nor my testing equipment to thoroughly test them out. Still could be a problem there.
Thanks for the help! | |
|
Massey 8650 Problems
