|
NW Iowa | T4151 is transmission oil temp above 203 degrees F. Probably have a bad sensor or wire. It is located on the right side of transmission. Easy to test 10417 ohms is 0 degrees C, 131 ohms is 125C, and 17382 ohms is -10C. Again check your wire plug, pin one is signal the other is ground.
4332 is excess pressure detected, metering pump fault, module above or below pressure, draining interrupted at previous stop
Normally if you don't let it drain down before hitting reset this comes up. Just shut off normal and restart again and it should go away. Otherwise usually its a hose going bad, or a bad nozzle or something in the nozzle. When was the last time the filter was changed on the module?
4356 is def module relay open circuit.
Check your fuses, relay, and battery box connections for the battery and relay box. Bad hose connections or hoses cause this also
My bet is you have battery connection issues
Also check those connectors under the step by the module for the hoses. I've seen those pins get rotten and go bad.
If your batteries are getting old 5yrs or more might be a good time to replace them also.
What yr is this tractor and how many hrs are on it?
I would do all this before the tech comes out. The service call alone will pay you to put new batteries in it if needed.
Edited by Massey1155 6/5/2019 07:35
| |
|
Massey 8650 Problems
