|
Boone, Iowa | I had my AGCO tech help me replace a hub seal last November. He had a homemade tool that was made out of a piece of pipe and had one end capped off with a hole. It may have had windows cut into one end. You need to press that full collar just enough to get those two half collars out of the groove. The piece in the picture is something I had on my shop press, just to give you an idea what I think it looked like.
Edited by jedeka 5/7/2019 10:25
(image (full).jpg)
Attachments ---------------- image (full).jpg (150KB - 41 downloads)
| |
|